Electrical Unit Converter

Decimal or scientific notation; select units separately.

Converted value

Enter a value to convert

Enter a value to see the aligned scales.

Visible range (source unit)

Target value = source value × source factor ÷ target factor

Show the steps

Enable JavaScript to convert values. Explanations, formulas and references remain available below.

Convert voltage, current, power, energy, charge, resistance, capacitance and inductance within the same physical quantity.

How to use

Choose the electrical quantity, enter a value, and select its source and target units.

Read the result and the one-unit conversion factor. Prefixes are case-sensitive: milli and mega differ by a billion.

Use the aligned scales to see how the same reading is expressed in both units. Edit the visible range or choose Fit value to include the reading without changing it.

Copy result includes the quantity and both unit-labeled values. Swap units preserves the reading while reversing the units. Reset clears the value and restores this block's starting quantity, unit pair and view.

Resistance, capacitance and inductance here are nonnegative passive-component magnitudes. Signed voltage, current, power, energy and charge are converted as entered.

Science

Metric prefixes multiply a unit by a power of ten. A millivolt is one thousandth of a volt; a microfarad is one millionth of a farad. Changing the prefix changes the number used to describe the same quantity.

Power is a rate of energy transfer. A watt is one joule per second, while a watt-hour is energy equal to 3,600 joules. This converter changes energy units but does not infer how long a device runs.

Current is a rate of charge flow. An ampere-hour is charge equal to 3,600 coulombs. Ampere-hours and watt-hours describe different quantities; converting between them needs voltage information and an appropriate physical model, which this tool does not supply.

Resistance, capacitance and inductance have units of ohms, farads and henries. Converting these units does not determine circuit behavior, AC impedance, component tolerance or a safe operating rating.

The factors are exact definitions, but computer arithmetic and display rounding are approximate. The converted number cannot be more accurate than the original measurement.

Formulas

Prefix or same-quantity conversion: target value = source value × source factor ÷ target factor; factors are canonical units per selected unit

Energy units: 1 W·h = 3,600 J

Charge units: 1 A·h = 3,600 C

Examples

3.3 V: 3300 mV. The voltage is unchanged; each volt contains 1,000 millivolts.

4700 Ω: 4.7 kΩ. Kilo means 1,000, so divide the ohm reading by 1,000.

100 nF: 0.1 µF. These are two descriptions of the same capacitance.

2.5 W·h: 9000 J. Multiply the energy by 3,600.

2500 mA·h: 2.5 A·h → 9000 C. These are charge units, not energy units.

0 mH: 0 H. Zero is accepted; a negative passive inductance is outside this tool's domain.

References

BIPM SI Brochure, ninth edition, version 4.01 (June 2026)

NIST SP 330, Section 2

NIST SP 811, Appendix B.8

NIST: SI Units—Electric Current